 PM's to Mr. Warner
I have posted info by PM. Cutters described are from discounttools.com and are in "Tapered end mills" section of milling cutters. Further interest by Mr. Warner would keep me optomistic. If I were really skilled with one of my cone mandrels, I would just lay the heated steel coupon at the edge of the face, hold it down wiith the cone mandrel, hammer up to start the wrap around, continue wrapping around the cone and then when overlapping, flux, forge weld and clean up. I am not anywhere near good enough to do that yet, not even close! Regards to all and thanks to Mr. Warner for his interest and possible offer to help fabricate the block. jet
|