There are a number of ways....
As you said, casting.... Using a low temp metal (lower than steel) such as aluminum or pewter, cast a handle, then insert the tang (long end of the utensil - hidden in the handle). Cool and clean.
Make a handle where the tang passes completely through the handle and exits the end. Thread the end and add a cap, or bend the end over to hold.
Handle a handle, usually two piece, with a channel down the middle for the tang. Drill two or more holes through all the pieces. Use rivets or screws to secure....
There are probably other ways but these are the most common ways I know....Much will depend on the size and end-use of the item you are creating as each method has its pluses and minuses....
|