Quantcast Blacksmith Forum - View Single Post - climb milling on the bridgeport , thoughts

Thread: climb milling on the bridgeport , thoughts
View Single Post

  #13 (permalink)  
Old 02-26-2008, 02:18 AM
SoldierSpud SoldierSpud is offline
Junior Member
  
Join Date: Feb 2008
Location: I am stationed at Ft. richardson Ak
Posts: 2
Default climb milling
I am a machinist in the Army and have about 2 and a half years of experience. If you are going to climb mill, I would say go 5 to 10 thousanths at the most. It leaves a very nice finish. Slow and steady. if you stop in the middle of the cut it will leave a notch.
Reply With Quote