Quantcast Blacksmith Forum - View Single Post - Straightening a Shaft!??

Thread: Straightening a Shaft!??
View Single Post

  #5 (permalink)  
Old 02-21-2008, 04:16 PM
IronPuppet's Avatar
IronPuppet IronPuppet is offline
Senior Member
  
Join Date: Sep 2006
Location: Saskatchewan
Posts: 105
Default
I just straightened the axle of my snow blower. Heated it red hot in the forge and tapped it lightly on the anvil with my big hammer. Worked fine. Axle is 3/4" drill rod.

IP
__________________
Forging ahead!
Reply With Quote